000			02402nam a2200241 4500
008			250510t2020 |||ado|g m||| 00| 0 eng d
040			_aUniversiti Teknologi Brunei _beng _cUTB
084			_aUTB 120 THESIS REPORTS & DISSERTATION _aRTDS 379
100	1		_aMuhammad Haziq Bin Haji Awang Jaafar, _eauthor.
245	1	0	_aEco-Friendly Machining Of Marine Grade AISI 316 Stainless Steel / _cMuhammad Haziq Bin Haji Awang Jaafar.
260			_aBandar Seri Begawan : _bUniversiti Teknologi Brunei, _c©2022.
300			_a94 pages : _bcolor illustrations, photos, charts ; _c30 cm.
500			_aA thesis submitted to The Universiti Teknologi Brunei (UTB) in partial fulfillment of the requirements for the degree of Master of Science (MSc) in Mechanical Engineering.
500			_aABSTRACT Milling AISI 316 stainless steel conventionally employs cutting fluids to reduce high-temperature generation associated with higher cutting speed, feed rate, and depth of cut. Unfortunately, cutting fluids can cause several issues in terms of the environment, health, and production costs. This study aims to conduct quantitative experimental research on the effectiveness of minimum quantity lubrication in AISI 316 stainless steel milling. Taguchi's orthogonal array was used in this experiment, which was found to significantly reduce the number of experiments required compared to a full factorial design. In addition, the signal-to-noise ratio, ANOVA, linear regression analysis, and confirmation test were performed. The spindle speed, feed rate, depth of cut, and flow rate of 1500 rpm, 360 mm/min, 0.2 mm, and 200 mL/h were the best parameters for achieving low surface roughness. Spindle speed, feed rate, depth of cut, and flow rate of 500 rpm, 360 mm/min, 0.1 mm, and 40000 mL/h, respectively, were optimal conditions for obtaining low burr height. The most significant parameters affecting surface roughness and burr height were spindle speed and depth of cut, respectively.
502			_aThesis (Degree) -Universiti Teknologi Brunei, 2022.
610		4	_aUniversiti Teknologi Brunei _xDissertations.
650		4	_aThesis writing.
650		4	_aStainless steel _xMachining.
650		4	_aAustenitic stainless steel.
700	1		_cMohammad Yeakub Ali, Prof. Ir. Dr., _esupervisor.
942			_2ddc _cRTDS
998			_eReports, Thesis & Dissertation _s850375 : 002226 c.1_UTB _xUniversiti Teknologi Brunei
999			_c23378 _d23378